- Description
Manual
PAGE-1
Description
Input Voltage |
DC+12V |
Standby |
Display shows:00:00, rely: Normal Open (NO) |
Accumulated time |
Yes, add time if receive signals again when time is running |
Max current load |
15A |
How it works |
|
Mode 1 |
Time runs down after receive signals-> Display shows remaining time and supply power to device-> it cuts off power after time runs out |
Mode 2 (Connect a button) |
Display shows remaining time after receive signals-> push button start-> time runs down and supply power to device-> it cuts off power after time runs out |
Pause (connect a button) |
Push button pause: it cuts off power when pause, display shows remaining time. Re-supply power after push button pause again |
Operating Mode |
Please reference to page 2 |
Connection Example |
Please reference to page 2 |
Connection and Position
|
|
Setting
Please follow CODE ON DISPLAY and use button "S1" and "S2" to set up number
- INPUT SIGNAL QUANTITY AND TIME
- Please press button "S4". “B” flashes. Please set up INPUT SIGNAL QUANTITY to active device (01-50).
- Please press button "S4", “A” flashes. Please set up TIME (01-99).
- Please press button "S4", “B” flashes. Please set up TIME (01-99).
- Please press button “S4” 4 TIMES.
- Please set up TIME for Warning Sound.
- Please press button "S4" to finish.
PAGE-2
- GIVEN TIME: Add time by free if input signals reach SETTING RATE during time is running.
Example Setting: input signal to active device: 01, input signals for given time: 03 give time: 02:10
Add time “02:10” free if receive “3 signals” during time is running.
- Please press button "S4" 4 TIMES. “B” flashes. Please set up RATE OF INPUT SIGNAL QUANTITY.
- Please press button "S4", “A” flashes. Please set up GIVEN TIME.
- Please press button "S4", “B” flashes. Please set up GIVEN TIME.
- Please press button "S4" to finish.
- Mode Setting
Please follow table to set up operating function:
- Please hold on button "S1" and "S2" simultaneously for 3 seconds to get into MODE SETTING.
- Please use button "S1" and button "S2" to set up number for CODE
- Please press button "S4" to switch to next code
Function |
Code on Display |
Description |
|
A |
B |
||
Running Time |
01 |
01 |
Time runs down without pressing button |
02 |
Time runs down by pressing button |
||
Time Type |
02 |
03 |
MINUTE: SECOND |
04 |
HOUR: MINUTE |
||
Memory |
03 |
05 |
Yes: Remaining time keep running after power off and on |
06 |
No: Standby power off and on |
||
Back to standby |
04 |
1-30 |
user has no action after push buttons or receive signals in setting time |
Default: 01-03: Bold and base line. 04: not use the function. |
Connection Example
comparison
Main board
Display